工作時,先把要加工螺紋的管子放進管子卡盤,撞擊卡緊,按下啟動開關,管子就隨卡盤轉動起來,調節好板牙頭上的板牙開口大小,設定好絲口長短.然后順時針扳動進刀手輪,使板牙頭上的板牙刀以恒力貼緊轉動的管子的端部,板牙刀就自動切削套絲,同時冷卻系統自動為板牙刀噴油冷卻,等絲口加工到預先設定的長度時,板牙刀就會自動張開,絲口加工結束.關閉電源,撞開卡盤,取出管子.
套絲機還具有管子切斷功能:把管子放入管子卡盤,撞擊卡緊,啟動開關,放下進刀裝置上的割刀架,扳動進刀手輪,使割刀架上的刀片移動至想要割斷的長度點,漸漸旋轉割刀上的手柄,使刀片擠壓轉動的管子,管子轉動4圈5圈后被刀片擠壓切斷.